Determination of transient creep parameters for HPSN by dynamic bending tests

Research paper by T. Fett, D. Munz

Indexed on: 01 Jun '84Published on: 01 Jun '84Published in: Journal of Materials Science

Abstract

A procedure is proposed which allows to determine creep parameters, mainly in the transient creep range, by dynamic bending tests. From measurements on HPSN at 1200° C creep exponents in the range 5<n<12 were found. The influence of creep on bending strength is investigated.

Determination of transient creep parameters for HPSN by dynamic bending tests

Abstract

More like this:

The effects of creep and recovery on the in vitro biomechanical characteristics of human multi-level thoracolumbar spinal segments.

Creep of heat-resistant steel under a bending load caused by the Gorskii effect

Materials, Vol. 12, Pages 3357: Comparison of Concrete Creep in Compression, Tension, and Bending under Drying Condition

Determination of transient creep parameters for HPSN by dynamic bending tests

Abstract

More like this:

The effects of creep and recovery on the in vitro biomechanical characteristics of human multi-level thoracolumbar spinal segments.

Creep of heat-resistant steel under a bending load caused by the Gorskii effect

Materials, Vol. 12, Pages 3357: Comparison of Concrete Creep in Compression, Tension, and Bending under Drying Condition

This website uses cookies